Home > SPICE Projects > General Electronics

> Light Switching Circuits

Projects

Light Switching Circuits

SPICE projects of Analog Switches, Light Switches, Safety Switches, Auto-Off Power and Load-Disconnect Switches

Sort by

  • Lamp Dimmer with PICDEM 2plus Board

    Created by EETACcataluna, published on 23-11-2012

    lamp dimmer application with the PICDEM 2plus board of Microchip with PIC16F877A microcontroller. A switch changes between two different duty cycle, when the switch is ON duty cycle is 70%, when it's OFF DC is 30%.

    FREE

    (only to registered users)

    Project Type: Free

    Complexity Spice Software Software Version Full version Components number
    Simple Proteus 7.6+ Yes 31-50

    Path: SPICE Projects > General Electronics > Light Switching Circuits

  • Light Bulb Dimmer with Triac Diac solution

    Created by LTspiceDesigner, published on 16-10-2012

    Spice simulation parametric analysis of a light bulb dimmer implemented with a triac-diac and a resistor which can assume a list of values from 1K to 325k. The source is 120V 60Hz.

    FREE

    (only to registered users)

    Project Type: Free

    Complexity Spice Software Software Version Full version Components number
    Simple LTspice IV No <10

    Path: SPICE Projects > General Electronics > Light Switching Circuits

  • Arduino Triac Power Regulator with Potentiometer

    Created by joserami, published on 15-10-2012

    This project use the triac power regulator to regulate the intensity of lamp light by a potentiometer connected to the microcontroller.

    FREE

    (only to registered users)

    Project Type: Free

    Complexity Spice Software Software Version Full version Components number
    Intermediate Proteus 7.7+ Yes 21-30

    Path: SPICE Projects > General Electronics > Light Switching Circuits

  • Triac Power Regulator for Dimmer Lamp with Arduino

    Created by joserami, published on 14-10-2012

    This is a control power triac with eight levels of power. The project uses three different fixed resistors that are properly isolated by three optoisolators drived by Arduino board in order to obtain eight power levels. This simulation lights a lamp cyclically and gradually.

    FREE

    (only to registered users)

    Project Type: Free

    Complexity Spice Software Software Version Full version Components number
    Intermediate Proteus 7.7+ Yes 21-30

    Path: SPICE Projects > General Electronics > Light Switching Circuits

  • Time Division Multiplexer with 4016

    Created by EDWin2011, published on 19-12-2011

    two different inputs (a sine wave and a square wave), are time-mixed by a quad bilateral switch CD4016 that drive a LM741 operational amplifier. The respective control input pins are alternately active through an inverter 7404

    FREE

    (only to registered users)

    Project Type: Free

    Complexity Spice Software Software Version Full version Components number
    Simple EDWinXP 1.61+ No 11-20

    Path: SPICE Projects > General Electronics > Light Switching Circuits

  • Light Switch with Thyristor

    Created by TINADesigner, published on 09-04-2011

    Light switch with two push buttons to turn on and turn off implemented with a thyristor

    FREE

    (only to registered users)

    Project Type: Free

    Complexity Spice Software Software Version Full version Components number Documents
    Simple Tina 7+ No <10 1

    Path: SPICE Projects > General Electronics > Light Switching Circuits

Pag. 1 of 1 (6 projects found)

1