Your cart contains 0 products
SPICE projects of RF Audio, Video, Data Transmitters, Receivers, Transceivers, Every Tipologies of Modulators, Demodulators, RF Amplifiers, etc
Created by glagator, published on 21-03-2013
Hartley oscillator with N-channel jfet
Project Type: Share
| Complexity | Spice Software | Software Version | Full version | Components number |
|---|---|---|---|---|
| Intermediate | NI Multisim | 10 | No | 11-20 |
Path: SPICE Projects > Radio Circuits > RF Amplifiers
Created by tobytone, published on 22-12-2012
The AD633 IC is a four-quadrant analog multiplier with differential X and Y inputs, and a high impedance summing input (Z). with the Z input connected to the carrier we obtain a double sideband full carrier modulated signal (DSBFC), if the Z input is connected to the ground the modulator produces a Double-sideband suppressed carrier signal (DSBSC) eliminating the carrier and transmitting the sidebands only. Here it's tested in both mode with a speech txt file as input signal.
FREE
(only to registered users)
Project Type: Free
| Complexity | Spice Software | Software Version | Full version | Components number |
|---|---|---|---|---|
| Intermediate | PSpice | 16.3+ | Yes | <10 |
Path: SPICE Projects > Radio Circuits > Modulators
Created by tobytone, published on 18-12-2012
a modulating signal, in this case a 2 khz sinusoidal frequency, modulates the amplitude of the 100 khz carrier.This modulation is also called double sideband full carrier (DSBFC) and produces in the spectrum a fcarrier+fmodulating, and fcarrier-fmodulating frequency components, with a bandwidth of 2*fmodulating, 4 khz. The operational amplifier is a LF411.
FREE
(only to registered users)
Project Type: Free
| Complexity | Spice Software | Software Version | Full version | Components number |
|---|---|---|---|---|
| Simple | PSpice | 9.1+ | No | <10 |
Path: SPICE Projects > Radio Circuits > Modulators
Created by tobytone, published on 12-12-2012
This circuit is a PCM system that uses 4 of the 8 bits available. The input signal is a 1Khz sinusoidal sampled at 8khz, which is the rate used in the public switched telephone network (PSTN), and the ADC parallel output it's converted to a serial bit stream. To show the recovered signal, a serial to parallel converter and a DAC is attached to the transmitter. The DAC output is low pass filtered.
FREE
(only to registered users)
Project Type: Free
| Complexity | Spice Software | Software Version | Full version | Components number |
|---|---|---|---|---|
| Intermediate | PSpice | 9.1+ | No | 11-20 |
Path: SPICE Projects > Radio Circuits > Modulators
Created by MicroCapDesigner, published on 31-10-2012
Integrated circuit for low power communication systems from 800-1200 Mhz. The receiver consists of a single balanced mixer with four bipolar transistors.
FREE
(only to registered users)
Project Type: Free
| Complexity | Spice Software | Software Version | Full version | Components number |
|---|---|---|---|---|
| Intermediate | Micro-Cap | 9+ | No | 31-50 |
Path: SPICE Projects > Radio Circuits > Receivers
Created by MicroCapDesigner, published on 10-05-2012
This mixer is usable for frequencies around 500Mhz. Discrete transistors mixers require the matching of the transistors' characteristics. This issue is overcome by applying a bit of feedback through emitter resistors. The base are driven with LO signal from a balun transformer. This mixer exhibits a conversion loss of 6dB and 15 to 17dBm of LO drive power.
FREE
(only to registered users)
Project Type: Free
| Complexity | Spice Software | Software Version | Full version | Components number |
|---|---|---|---|---|
| Intermediate | Micro-Cap | 10+ | No | 21-30 |
Path: SPICE Projects > Radio Circuits > Receivers
Created by MicroCapDesigner, published on 03-05-2012
This circuit implements a CMOS conversion gain active mixer. The voltage conversion gain is the ratio of the RMS voltages of IF and RF signals.The power conversion gain is the ratio of the power delivered to the load and the power available to RF input.
FREE
(only to registered users)
Project Type: Free
| Complexity | Spice Software | Software Version | Full version | Components number |
|---|---|---|---|---|
| Intermediate | Micro-Cap | 9+ | No | 31-50 |
Path: SPICE Projects > Radio Circuits > Receivers
Created by MicroCapDesigner, published on 24-04-2012
In this circuit both radio and local oscillator frequencies are suppressed in the output signal and the same for even order LO and RF harmonics. It provides an high degree of port to port isolation
FREE
(only to registered users)
Project Type: Free
| Complexity | Spice Software | Software Version | Full version | Components number |
|---|---|---|---|---|
| Intermediate | Micro-Cap | 9+ | No | 21-30 |
Path: SPICE Projects > Radio Circuits > Receivers
Created by TINADesigner, published on 02-11-2011
PWM demodulator implemented with an active low-pass filter with TL071 and TL072 operational amplifiers.
FREE
(only to registered users)
Project Type: Free
| Complexity | Spice Software | Software Version | Full version | Components number |
|---|---|---|---|---|
| Intermediate | Tina | 7+ | Yes | 21-30 |
Path: SPICE Projects > Radio Circuits > Demodulators
Created by TINADesigner, published on 31-10-2011
Pulse Width modulation modulator circuit implemented with 4 operational amplifiers, 2 LP3111 and 2 TL072. A first couple provides a triangular waveform compared with the message input signal. A last operational amplifier works as buffer.
FREE
(only to registered users)
Project Type: Free
| Complexity | Spice Software | Software Version | Full version | Components number |
|---|---|---|---|---|
| Intermediate | Tina | 7+ | Yes | 11-20 |
Path: SPICE Projects > Radio Circuits > Modulators