Your cart contains 0 products
> Power IC Amplifiers
Projects
- Control Systems (7)
- Digital Filters (10)
- Electrical Circuits (7)
- Transmission Lines (5)
-
General Electronics (225)
- Active filters (35)
- Motor Control Circuits (11)
- Light Switching Circuits (6)
- Sample And Hold Circuits (2)
- Relay Circuits (1)
- Tesla Coil Circuits (1)
- Piezo Circuits (4)
- Noise Reduction Circuits (1)
- Laser Circuits (6)
- Driver Circuits (6)
- Infrared Circuits (4)
- Ultrasonic Circuits (2)
- Optical Circuits (8)
- Digital To Analog Converters (4)
- Passive Filters (5)
- Analog To Digital Converters (3)
- Operational Amplifiers (28)
- Digital Basic Components (56)
- Analog Components (42)
- Power And Battery Circuits (97)
- Audio Circuits (61)
- Signal Generation Circuits (38)
- Sensors And Measure Circuits (13)
- Radio Circuits (30)
- Photovoltaic Circuits (10)
- Microcontroller Circuits (35)
-
Consumer Circuits (9)
- Model Hobby Circuits (0)
- Electronic Lock Circuits (0)
- Telephone Related Circuits (0)
- Photography Related Circuits (1)
- Wheater Related Circuits (1)
- Touch-Control Circuits (0)
- Musical Circuits (0)
- Medical Circuits (1)
- Light Control Circuits (5)
- Computer Circuits (0)
- Bugging Microtransmitter Circuits (0)
- Automotive Circuits (1)
- Robots (3)
- Domotic Circuits (1)
- PLC (0)
Power IC Amplifiers
SPICE projects of Power Amplifiers implemented with Integrated Circuits
-
OpAmp Booster
Created by bill9999, published on 03-03-2013
Cheap Audio Power amp using common OpAmp and Transistors
FREE
(only to registered users)
Project Type: Free
Complexity Spice Software Software Version Full version Components number Intermediate Tina-TI 9 No 51-100 Path: SPICE Projects > Audio Circuits > Power Amplifiers > Power IC Amplifiers
-
Class D Audio Power Amplifier with built in Boost Converter
Created by TINADesigner, published on 06-09-2012
the TPA2015D1 is an high efficiency class D power amplifier. It has a built in boost converter to enhances efficiency at low power. An automatic gain control adjusts the class D gain to limit battery current and prevent clipping. An integrated low pass filter improves RF rejection and increases the signal to noise ratio SNR.The simulation is performed with a speaker modeled as an 8 ohm resistive load with its reactive components.
FREE
(only to registered users)
Project Type: Free
Complexity Spice Software Software Version Full version Components number Simple Tina 7+ Yes 11-20 Path: SPICE Projects > Audio Circuits > Power Amplifiers > Power IC Amplifiers
-
20 Watt IC Power Amplifier
Created by NiMultisimDesigner, published on 14-08-2011
20 Watt monolithic integrated circuit LM1875T on 4 Ohm load, with single power supply of 48V.
FREE
(only to registered users)
Project Type: Free
Complexity Spice Software Software Version Full version Components number Intermediate NI Multisim 11+ Yes 11-20 Path: SPICE Projects > Audio Circuits > Power Amplifiers > Power IC Amplifiers
-
IC 14 Watt Amplifier
Created by NiMultisimDesigner, published on 14-08-2011
14 Watt Hi-fi audio amplifier on a 4 Ohm load,with TDA2030 integrated circuit, + - 14V Voltage supplies.
FREE
(only to registered users)
Project Type: Free
Complexity Spice Software Software Version Full version Components number Intermediate NI Multisim 11+ Yes 11-20 Path: SPICE Projects > Audio Circuits > Power Amplifiers > Power IC Amplifiers
Pag. 1 of 1 (4 projects found)
1
